HMC-W Water Mold Temperature Controller


Basic introduction
Model definition
Special Features
Note
  • HMC-WG Water Mold temperature controller is used to heat up the mold and maintains temperature, also can be used in other similar applications. Use common tap water as the medium, the boiling point of water synchronization pressure increase this characteristic, and use water low viscosity, achieve rapid temperature, the temperature of the heat transfer effect .


  • Type Unit HMC-6W
    HMC-6WG
    HMC-9W
    HMC-9WG
    HMC-12W
    HMC-12WG
    HMC-18W
    HMC-18WG
    HMC-24W
    HMC-24WG
    HMC-6W-D
    HMC-6WG-D
    HMC-9W-D
    HMC-9WG-D
    HMC-12W-D
    HMC-12WG-D
    Medium Water
    Max temp W=90℃   WG=120℃
    Heat power kW 6 9 12 18 24 6x2 9x2 12x2
    Pump power kW 0.37 0.75 0.75 1.5 2.2 0.37x2 0.75x2 0.75x2
    Max pump flow L/min 42 56 135 160 315 42x2 56x2 135x2
    Max pump pressure Bar 2.8 3.8 2.5 2.7 3.0 2.8 3.8 2.5
    Cooling method Direct
    Mould coupling W Ø10(2x2) Ø10(2x2) Ø10(4x2) Ø10(6x2) Ø10(6x2) Ø10(2-2x2) Ø10(2-2x2) Ø10(2-4x2)
    WG 3/8”(2x2) 3/8”(2x2) 3/8”(4x2) 3/8”(6x2) 3/8”(6x2) 3/8”(2-2x2) 3/8”(2-2x2) 3/8”(2-4x2)
     
    Dimensions  
    H mm 695 695 755 755 885 695 695 755
    W mm 310 310 350 350 410 600 600 700
    D mm 845 895 905 1025 1025 855 905 905


    Type Unit HMC-9WP HMC-9WP3 HMC-9WP-D HMC-9WP3-D
    Medium   Water
    Max temp   160℃
    Heat power kW 9 9 9x2 9x2
    Pump power kW 0.75 2.2 0.75 x2 2.2 x2
    Max pump flow L/min 135 240 135 x2 240 x2
    Max pump pressure Bar 2.5 3.6 2.5 x2 3.6 x2
    Cooling method   Indirect
    Mould coupling inch 3/8”(4x2) 3/8”(4x2) 3/8”(2-4x2) 3/8”(2-4x2)
     
    Dimensions  
    H mm 775 815 775 815
    W mm 350 350 700 700
    D mm 915 995 915 995


    Note

  • The standard voltage is 3 Phase, 380V, 50 Hz.
  • Refer to the heating capacity to select the machine.
  • Have any special needs, please contact us.
  • We reserve right to change specifications without prior notice.